跳到正文
ECA GMP News·精选AI 评分81

欧洲药典拟新增 3.3.9 章预灌封塑料注射器并征求意见至 2026 年 9 月 30 日

Proposal for New Ph. Eur. Chapter on Prefillable Syringes

AI 导读

欧洲药典拟新增第 3.3.9 章注射用液体制剂用预灌封塑料注射器,征求意见截止 2026 年 9 月 30 日。草案涵盖 COP、COC、PP 等常用材料要求,并包含可见与亚可见颗粒、细菌内毒素、硅油、透明度等检测项目。若采用环氧乙烷灭菌,需符合 GC-MS 残留环氧乙烷检测要求,限值为不超过 10 ppm;草案已刊于 Pharmeuropa 38.3。

推荐理由

材料介绍欧洲药典拟新增 3.3.9 章草案的适用对象、材料与检测要求及征求意见截止日,便于读者定位需核对的章节。

正文 · 原文

A new Ph. Eur. chapter 3.3.9. Prefillable plastic syringes for liquid preparations for injection is being proposed. The deadline for comments is 30 September 2026. Prefillable plastic syringes are containers intended to be filled with a medicinal product and to remain in direct contact with that medicinal product throughout its shelf life (i.e., Prefilled Syringes, PFS). They consist of a syringe barrel with a Luer connector and tip cap or a staked non-detachable needle and needle shield, and a plunger (stopper and rod). They are sterile and suitable for aseptic filling (i.e., Ready-to-Use (RTU) container), or are terminally sterilised after filling. MaterialsThe most commonly used materials for these syringes are cyclo-olefin polymers (COP, Ph. Eur. 3.1.16), cyclo-olefin copolymers (COC, Ph. Eur. 3.1.17) and polypropylene (PP, Ph. Eur. 3.1.6). The plastics and elastomer materials of which the barrel and plunger are made comply with appropriate specifications and/or with the requirements of the competent authority. If the plunger stopper, tip cap or needle shield is made of rubber, it complies with the requirements of Ph. Eur. chapter 3.2.9. (Rubber closures). If lubrication is required, silicone oil (Ph. Eur. 3.1.8) or another suitable lubricant may be applied to the internal wall of the barrel. TestsThe proposal includes requirements (among others) for visible and sub-visible particles, bacterial endotoxins, silicone oil, transparency, and supplementary tests. LabellingThe label states, where applicable, that the syringe has been sterilised and the method that has been used (e.g. using ethylene oxide or by irradiation). If the syringes are sterilised using ethylene oxide, they comply with the test for residual ethylene oxide using GC-MS (limit: not more than 10 ppm). For more information please see the draft chapter 3.3.9. Prefillable plastic syringes for liquid preparations for injection published in Pharmeuropa 38.3.

来源:ECA GMP News · gmp-compliance.org