FDA 检查后向龙沙 Bend 工厂发出 483,列出垫圈异物与 PI 系统数据丢失等重复偏差观察
FDA483:龙沙PI系统频繁数据丢失整改无效,数据迁移丢失数据,垫圈异物频发,清洁执行和目检人员一致
FDA 对龙沙 Bend Inc.(俄勒冈州 Bend,FEI 3003722743)2026 年 5 月 12 日至 19 日的检查发出 483,观察项 1 为未对无法解释的差异彻底审核、偏差未做趋势分析。
本文中观点不代表任何公司和组织,如有觉得有冒犯的地方,请于后台联系,我会及时删除。所有分享案例都具有孤立性,仅供参考。
受检机构/公司:Lonza Bend Inc.
城市:俄勒冈州 Bend,邮编 97701-8507,美国
类型:Manufacturer
FEI号:3003722743
检查员:
·Roger F Zabinski, National Expert 罗杰·F·扎宾斯基,国家专家(FDA技术职称最高级别)
·Ana-Maria A Plapcianu, Microbiologist 安娜-玛丽亚·A·普拉普恰努,微生物学家
·Conor J Mccarron, Investigator 康纳·J·麦卡伦,检查员
·Eric Zhu, Investigator 朱(Eric Zhu),检查员
检查日期:5/12/2026 – 5/19/2026
DURING AN INSPECTION OF YOUR FIRM WE OBSERVED:
在对贵企业实施检查期间,我们观察到:
观察项 1 / Observation 1
There is a failure to thoroughly review any unexplained discrepancy whether or not the batch has been already distributed.
未能对任何无法解释的差异进行彻底审核,无论该批产品是否已放行(销售)。
Specifically,
具体而言,
Deviations are not always trended to prevent recurrence. For example, the following deviations show repeat events:
偏差并非总是经过趋势分析以预防复发。例如,以下偏差显示出重复发生的情况:
A. Gasket Deviations / A. 垫圈相关偏差
偏差编号 Deviation # | 日期 Date | 简述 Short Description |
DR-2025-0318 | 12/7/2024 | xxx were found to contain nitrile gaskets instead of specified xxx gaskets. Error traced to xxx purchased starting 9/06/2024. Nitrile gasket xxx installed in xxx, xxx, and xxx across multiple xxx work orders. xxx product lots assessed including DPI, xxx, and xxx. 经查,xxx 中含有丁腈橡胶垫圈,而非规定的 xxx 垫圈。错误追溯至 2024 年 9 月 6 日起采购的 xxx。丁腈橡胶垫圈 xxx 被安装于 xxx、xxx 及 xxx 中(涉及多个 xxx 工单)。评估了包括 DPI、xxx 和 xxx 在内的 xxx 批次产品。 |
DR-2025-0316 | 11/16/2025 | Extraneous material observed in xxx following execution of lot xxx of xxx. xxx lots assessed in total. All extraneous matter particles were found upstream of xxx. The particles were later found to be due to incorrect gasket(s) used. 在执行 xxx 的 xxx 批次后,于 xxx 中观察到外来物质。共计评估 xxx 批。所有外来颗粒均发现于 xxx 的上游。颗粒后被查明系使用了错误的垫圈所致。 |
DR-2025-0291 | 10/30/2025 | During minor cleaning following manufacture of xxx lot xxx, extraneous material observed inside xxx. Damaged O-ring and extraneous matter particles were found. The particles were identified as xxx. 在 xxx 批次 xxx 生产后的清洁过程中,于 xxx 内部观察到外来物质。发现 O 型圈损坏及外来物质颗粒,颗粒被鉴定为 xxx。 |
DR-2025-0278 | 10/20/2025 | Unusual pressure and flow were observed during production of xxx lot xxx. This prompted nozzle inspection. xxx xxx extraneous matter was discovered in the xxx nozzle. 在 xxx 批次 xxx 的生产过程中观察到异常的压力与流量,由此对喷嘴进行了检查。在 xxx 喷嘴中发现 xxx xxx 外来物质。 |
DR-2025-0198 | 8/8/2025 | Abnormal nozzle pressure and feed rate observed during execution of DPI xxx lot xxx. Nozzle inspection revealed extraneous matter identified as xxx from gasket. 在执行 DPI xxx 批次 xxx 期间观察到喷嘴压力与进料速率异常。喷嘴检查发现外来物质,经鉴定为来自垫圈的 xxx。 |
DR-2025-0142 | 6/2/2025 | During minor cleaning of the xxx a damaged gasket was observed at the base of the xxx housing. Shreds of black material consistent with gasket materials visible inside the housing. 在对 xxx 进行清洁期间,于 xxx 壳体底部观察到一处损坏的垫圈;壳体内可见与垫圈材料相符的黑色材料碎屑。 |
B. Data Loss and Storage Discrepancies / B. 数据丢失与存储差异
偏差编号 Deviation # | 日期 Date | 简述 Short Description |
DR-2026-0084 | 11/1/2025 | A data gap existed between xxx migration for a period from 11/01/2025 – 12/20/2025 for the xxx system. The IT department reported the servers only had backups for a xxx. xxx 系统在 xxx 迁移之间存在数据差异,时间自 2025 年 11 月 1 日至 12 月 20 日。IT 部门报告服务器仅有 xxx 的备份。 |
DR-2026-0030 | 1/24/2026 | The entire PI system at Lonza Bend xxx warehouse lost data on 1/24/2026 for three minutes. Lonza Bend 的 xxx 仓库整个 PI 系统于 2026 年 1 月 24 日丢失数据三分钟。 |
DR-2026-0021 | 1/20/2026 | Lonza Bend system PI data was lost on xxx for 30 minutes on 1/20/2026 for xxx. Lonza Bend 系统 PI 数据于 2026 年 1 月 20 日在 xxx 上丢失 30 分钟(涉及 xxx)。 |
DR-2026-0009 | 12/6/2025 | During investigation of DR-2025-0330, it was discovered there was missing audit trail entries for xxx from 12/04/2025 – 1/13/2026 for xxx SDI. 在对 DR-2025-0330 的调查过程中发现,xxx SDI 于 2025 年 12 月 4 日至 2026 年 1 月 13 日期间存在 xxx 的审计追踪条目缺失。 |
DR-2025-0347 | 12/19/2025 | Facility Monitoring System (FMS) lost connection with the PI data server from 12/19/2025 13:47 to 12/20/2025 10:52. 设施监测系统(FMS)与 PI 数据服务器失去连接,时间为 2025 年 12 月 19 日 13:47 至 12 月 20 日 10:52。 |
DR-2025-0315 | 3/14/2025 | During system audit trail review for xxx, it was found that batch report data was deleted off the system with date occurrence documented on 3/14/2025, observed on 10/22/2025 and launch of the deviation on 11/17/2025. 在对 xxx 进行系统审计追踪审查时发现,批报告数据被从系统中删除;发生日期记录为 2025 年 3 月 14 日,于 2025 年 10 月 22 日发现,该偏差于 2025 年 11 月 17 日发起。 |
DR-2025-0115 | 5/3/2025 | Multiple values recorded on xxx PI Data System were frozen from 12:02-14:57. Two manufacturing events were in process, including xxx. 记录于 xxx PI 数据系统上的多个数值在 12:02–14:57 期间被冻结。当时有两起生产事件正在进行,包括 xxx。 |
C. Missing Documentation of Manufacturing Activities / C. 生产活动文件记录缺失
偏差编号 Deviation # | 日期 Date | 简述 Short Description |
DR-2026-0117 | 4/21/2026 | Operator that performed clean on Commercial Skid Gasket was the same operator who performed the visual verification of that gasket. 对商业化滑橇垫圈执行清洁操作的操作员,与对该垫圈执行目视确认的操作员为同一人。 |
DR-2026-0104 | 2/15/2026 | During execution of protocol xxx, three sample sets were not signed off. 在执行方案 xxx 期间,三组样品未签署放行。 |
DR-2026-0080 | 3/10/2026 | During rinsing and cleaning testing for the xxx on 3/10/2026, documentation did not indicate which xxx the rinsate and micro were performed on. 于 2026 年 3 月 10 日对 xxx 进行的冲洗与清洁测试中,文件记录未指明冲洗水和微生物(检测)是在哪个 xxx 上执行的。 |
西门的吐槽:
关于数据丢失异常
PI系统,是工业领域一种用于实时数据采集、存储和监控的基础设施平台。它通过接口程序从 DCS、PLC、仪表等现场设备持续采集过程数据,存入时间序列数据库(PI Data Archive),供用户进行历史趋势分析、报表、报警监控和生产管理。广泛用于制药、化工、电力等流程工业,也是满足数据可靠性要求(如 FDA 21 CFR Part 11)的常见方案(虽然但是国内只有几家巨头用的起,但是个非常棒的系统)。
从这个案例可以看的出,TOP的系统+顶尖的质量体系(龙沙毕竟大厂子),依旧搞不定数据丢失这类问题的频发(不要质疑,越是信息化,数据丢失这种事情越是容易产生,PI系统本身一般也有缓存或者冗余的,但其实就是个大SCADA,对接各种系统,难免有异常)。
不要侥幸,任何的数据丢失必须是偏差,不存在瞒报(凡存在必有痕迹,而且墨菲定律,有些小技巧的情况下,很容易发现异常)或者隐藏到类似IT事件等短路径(因为检查员平常只要求看偏差台账,本身数据丢失就理不清说不明原理和影响,一旦知道你有短路经,还发现有数据丢失的异常,那会破坏审计双方的信任感,又质疑整个体系可靠性)。
这里龙哥的做法,其实是当前的唯一最正确的选择,就是发偏差。不瞒报。这里没有任何关于数据异常的差异,也证实了这点,评估写的好,不会被质疑数据可靠性。后面至少还有整改的机会。
来源:BasicPharma搬砖工 · mp.weixin.qq.com